WATERPROOFING ANCHORING CEMENT FOR CONCRETE AND MASONRY

Waterproofing Anchoring Cement.

For Use in Setting anchor bolts, rail posts, signposts, parking meters, park seats, bridge railings, safety rails, hand rails, partitions, balustrades, reinforcing rods and fixtures. Flag and light poles - Heavy machinery anchoring, hooks, pulleys.

Water Sewer Management, Road Rail, Construction Building, Swimming Pool Industry, Bridge Building, Councils, Heavy Industry, Mining, Steel, Defence Forces.

Is a mixture of cements and selected special additives and aggregates. A pourable, cement-base, non-shrinking, quick-setting hydraulic compound.

Drizoro Maxgrip quick-setting hydraulic compound.

Description

Maxgrip is a mixture of cements and selected special additives and aggregates. A pourable, cement-base, non-shrinking, quick-setting hydraulic compound.

Uses
Water/Sewer Management, Road/Rail, Construction Building/Swimming Pool Industry, Bridge Building, Councils, Heavy Industry, Mining, Steel, Defence Forces.

• Setting anchor bolts, rail posts, signposts. Parking meters, reinforcing rods and fixtures.

• Heavy machinery anchoring, hooks, pulleys.
• Park seats, bridge railings, partitions.
• Safety rails, hand rails, balustrades.
• Flag and light poles.

Advantages

• Quick setting - 15 minutes.
• Stronger than concrete in one hour.
• Grey Colour matching perfectly with concrete. Makes structurally sound bonds.
• Add water only - easy use.
• Waterproofs surface to which it is applied.
• Non-toxic. Odourless.
• Ideal for badly ventilated areas. Pourable.
• Contains no sulphur or Iron particles, will not oxidise.

Drill holes in sound concrete large enough for head and washer. If concrete is not sufficiently sound, drill deeper. To increase the strength mushroom the base of the hole by tilting the drill. Blow or vacuum out excess dust and wet sides of hole to obtain proper bonding. Place anchor bolts, with washer in hole. Mix enough material to fill the hole, mix with clean water a pancake batter consistency in a small plastic bowl or other suitable container. Pour a little MAXGRIP in the hole and work the bolt up and down a few times to eliminate any air bubbles. Pour in balance of mix from one side to ensure even flow.
MAXGRIP will set in 15 minutes, complete cure after 60 to 90 minutes and will strength as it cures, so allow more curing time for heavy machinery and other large installations.
For cold weather installations, heat hole before using MAXGRIP. Do not add antifreeze solutions to mixing water. Store material in a warm place.

Test Data

• Compressive strenght 7 days - 444 Kg/cm².
• Pullout strength 22 mm bolt in 80 mm hole = 109, 546 Kg/cm².
• Set time l-Vicat - 15 minutes.

Recommendations
Holesize should be 3 x the size of the bolt. This will ensure that the strength of the setting compares to the tensile strength of the mild steel bolt. Depth should be 5 x the diameter of the bolt or post.

Packaging

25 Kg. pails.
5 Kg. cans

Guarantee
The information contained in this leaflet is based on our experience and technical knowledge, obtained through laboratory testing and from bibliographic material. DRIZORO reserves the right to introduce changes without prior price. Any use of this data beyond the purposes expressly specified in the leaflet will not be the Company´s responsibility unless authorised by us. The data shown on consumptions, measurement and yields are for guidance only and based on our experience. These data are subject to variation due to the specific atmospheric and jobsite conditions so reasonable variations from the data may be experienced. In order to know the real data, a test on the jobsite must be done, and it will be carried out under the client responsibility. We shall not accept responsibility exceeding the value of the purchased product. For any other doubt, consult our Technical Department. This version of bulletin replaces the previous one.
Top